搜索

x

留言板

尊敬的读者、作者、审稿人, 关于本刊的投稿、审稿、编辑和出版的任何问题, 您可以本页添加留言。我们将尽快给您答复。谢谢您的支持!

姓名
邮箱
手机号码
标题
留言内容
验证码

液滴碰撞液膜润湿壁面空气夹带数值分析

李大树 仇性启 郑志伟

引用本文:
Citation:

液滴碰撞液膜润湿壁面空气夹带数值分析

李大树, 仇性启, 郑志伟

Numerical analysis on air entrapment during droplet impacting on a wetted surface

Li Da-Shu, Qiu Xing-Qi, Zheng Zhi-Wei
PDF
导出引用
  • 采用复合水平集-流体体积法并综合考虑传热及接触热阻的作用, 对液滴碰撞液膜润湿壁面空气夹带现象进行了数值分析. 揭示了夹带空气形成机理, 探索了夹带空气特性参数随碰撞速度和液膜厚度的变化规律, 获得了夹带空气作用下液滴碰撞润湿壁面的传热机理. 研究结果表明: 撞壁前气液两相压力差是引起气液相界面拓扑结构变化以及夹带空气形成的主要原因; 液滴碰撞速度与压缩空气层内压力以及相界面形变高度密切相关; 液滴接触液膜时, 碰撞轴上液滴底部和液膜表面速度相等, 大约是碰撞速度的1/2; 碰撞速度对夹带空气层底部到破碎点的无量纲弧长和最大无量纲夹带空气直径均存在较大的影响; 液滴和液膜的无量纲形变高度与斯托克斯数密切相关; 液膜初始厚度对液滴和液膜的无量纲形变高度和最大无量纲夹带空气直径影响较大; 撞壁初始阶段, 碰撞中心区域夹带空气对壁面热流密度分布存在较大的影响.
    A numerical model is developed using the coupled level set and volume of fluid method including heat transfer and contact resistance to simulate air entrapment during a droplet impacting on a wetted surface. The dynamic characteristics of the phase interface are analysed. The mechanisms of deformation of the phase interface and formation of entrapped air are explored. The effects of impacting velocity and thickness of liquid film on characteristics of entrapped air are studied. The mechanism of heat transfer is also obtained in this article. The obtained results are as follows. The pressure difference between liquid and gas before the droplet impacting is the main factor determining the deformation of phases interface and the formation of air entrapment. The larger the impacting velocity, the larger the pressure inside the compressed air film is. When the droplet contacts the liquid film, the velocities of the droplet and liquid film increase to their maximum values, and at the impacting axis, they are approximately the same, nearly half the impacting velocity. The velocity distributions of phase interface of the droplet and liquid film are nearly the same in the area of impacting center. The impacting velocity has important effects on the dimensionless arc from bottom to breaking point and the dimensionless diameter of the air. The dimensionless arc and dimensionless diameter decrease with increasing impacting velocity. The dimensionless deforming heights of the droplet and liquid film are closely related to Stokes number: the larger the Stokes number, the larger the dimensionless deforming heights are, and they can be expressed as a power function with Stokes number. The initial thickness of liquid film also affects dimensionless deforming heights of the droplet and liquid film and dimensionless diameter of the entrapped air: the larger the dimensionless thickness of the liquid film, the larger the dimensionless deforming heights are, and the dimensionless diameter decreases with increasing dimensionless thickness of the liquid film. At the very initial stage of the impact, the entrapped air is important for surface heat flux distribution. The entrapped air presents contraction, breakup and detachment. The surface heat flux distribution changes closely with evolution of the entrapped air and tends to be uniform. The effect of the entrapped air on the surface heat flux distribution decreases gradually.
      通信作者: 仇性启, apvshi@upc.edu.cn
    • 基金项目: 国家重大科技专项(批准号: GZH201200602-01)和中央高校基本科研业务费专项资金 (批准号: 15CX06052A)资助的课题.
      Corresponding author: Qiu Xing-Qi, apvshi@upc.edu.cn
    • Funds: Project supported by the National Science and Technology Major Project of the Ministry of Science and Technology of China (Grant No. GZH201200602-01) and the Fundamental Research Funds for the Central Universities, China (Grant No. 15CX06052A).
    [1]

    Moreira A L N, Moita A S, Panao M R 2010 Prog. Energ. Combust. 36 554

    [2]

    Guo J H, Dai S Q, Dai Q 2010 Acta Phys. Sin. 59 2601 (in Chinese) [郭加宏, 戴世强, 代钦 2010 物理学报 59 2601]

    [3]

    Liang G T, Guo Y L, Shen S Q 2013 Acta Phys. Sin. 62 184703 (in Chinese) [梁刚涛, 郭亚丽, 沈胜强 2013 物理学报 62 184703]

    [4]

    Lee S H, Hur N, Kang S 2011 J. Mech. Sci. Technol. 25 2567

    [5]

    Liang G T, Shen S Q, Yang Y 2012 J. Therm. Sci. Tech. 11 8 (in Chinese) [梁刚涛, 沈胜强, 杨勇 2012 热科学与技术 11 8]

    [6]

    Liang G T, Guo Y L, Shen S Q 2013 Acta Phys. Sin. 62 024705 (in Chinese) [梁刚涛, 郭亚丽, 沈胜强 2013 物理学报 62 024705]

    [7]

    Tran T, de Hlne M, Chao S, Lohse D 2013 J. Fluid Mech. 726 R31

    [8]

    Hendrix M H W 2013 M. S. Dissertation (Enschede: University of Twente)

    [9]

    Hicks P D, Purvis R 2011 Phys. Fluids 23 062104

    [10]

    Chen S, Guo L 2014 Chem. Eng. Sci. 109 1

    [11]

    Liang G, Guo Y, Shen S, Yang Y 2014 Theor. Comput. Fluid Dyn. 28 159

    [12]

    Thoroddsen S T, Etoh T G, Takehara K 2005 J. Fluid Mech. 545 203

    [13]

    Song Y C, Ning Z, Sun C H, Yan K, Fu J 2014 J. Mech. Eng. 50 153 (in Chinese) [宋云超, 宁智, 孙春华, 阎凯, 付娟 2014 机械工程学报 50 153]

    [14]

    Thoroddsen S T, Etoh T G, Takehara K 2003 J. Fluid Mech. 478 125

    [15]

    Li D S, Qiu X Q, Yu L, Xu J, Duan X L, Zheng Z W 2014 Ind. Heating 43 1 (in Chinese) [李大树, 仇性启, 于磊, 许京, 段小龙, 郑志伟 2014 工业加热 43 1]

    [16]

    Mehdi N V, Mostaghimi J, Chandra S 2002 Phys. Fluids 15 173

    [17]

    Brackbill J U, Kothe D B 1992 J. Comput. Phys. 100 335

    [18]

    Ubbink O, Issa R I 1999 J. Comput. Phys. 153 26

    [19]

    Lee J S, Weon B M, Je J H, Kamel F 2012 Phys. Rev. Lett. 109 204501

    [20]

    Liu Y, Tan P, Xu L 2013 J. Fluid Mech. 716 R9

  • [1]

    Moreira A L N, Moita A S, Panao M R 2010 Prog. Energ. Combust. 36 554

    [2]

    Guo J H, Dai S Q, Dai Q 2010 Acta Phys. Sin. 59 2601 (in Chinese) [郭加宏, 戴世强, 代钦 2010 物理学报 59 2601]

    [3]

    Liang G T, Guo Y L, Shen S Q 2013 Acta Phys. Sin. 62 184703 (in Chinese) [梁刚涛, 郭亚丽, 沈胜强 2013 物理学报 62 184703]

    [4]

    Lee S H, Hur N, Kang S 2011 J. Mech. Sci. Technol. 25 2567

    [5]

    Liang G T, Shen S Q, Yang Y 2012 J. Therm. Sci. Tech. 11 8 (in Chinese) [梁刚涛, 沈胜强, 杨勇 2012 热科学与技术 11 8]

    [6]

    Liang G T, Guo Y L, Shen S Q 2013 Acta Phys. Sin. 62 024705 (in Chinese) [梁刚涛, 郭亚丽, 沈胜强 2013 物理学报 62 024705]

    [7]

    Tran T, de Hlne M, Chao S, Lohse D 2013 J. Fluid Mech. 726 R31

    [8]

    Hendrix M H W 2013 M. S. Dissertation (Enschede: University of Twente)

    [9]

    Hicks P D, Purvis R 2011 Phys. Fluids 23 062104

    [10]

    Chen S, Guo L 2014 Chem. Eng. Sci. 109 1

    [11]

    Liang G, Guo Y, Shen S, Yang Y 2014 Theor. Comput. Fluid Dyn. 28 159

    [12]

    Thoroddsen S T, Etoh T G, Takehara K 2005 J. Fluid Mech. 545 203

    [13]

    Song Y C, Ning Z, Sun C H, Yan K, Fu J 2014 J. Mech. Eng. 50 153 (in Chinese) [宋云超, 宁智, 孙春华, 阎凯, 付娟 2014 机械工程学报 50 153]

    [14]

    Thoroddsen S T, Etoh T G, Takehara K 2003 J. Fluid Mech. 478 125

    [15]

    Li D S, Qiu X Q, Yu L, Xu J, Duan X L, Zheng Z W 2014 Ind. Heating 43 1 (in Chinese) [李大树, 仇性启, 于磊, 许京, 段小龙, 郑志伟 2014 工业加热 43 1]

    [16]

    Mehdi N V, Mostaghimi J, Chandra S 2002 Phys. Fluids 15 173

    [17]

    Brackbill J U, Kothe D B 1992 J. Comput. Phys. 100 335

    [18]

    Ubbink O, Issa R I 1999 J. Comput. Phys. 153 26

    [19]

    Lee J S, Weon B M, Je J H, Kamel F 2012 Phys. Rev. Lett. 109 204501

    [20]

    Liu Y, Tan P, Xu L 2013 J. Fluid Mech. 716 R9

计量
  • 文章访问数:  4917
  • PDF下载量:  220
  • 被引次数: 0
出版历程
  • 收稿日期:  2015-03-27
  • 修回日期:  2015-06-09
  • 刊出日期:  2015-11-05

/

返回文章
返回