Phase noise is a critical metric of microwave signal quality and directly affects the performance of wireless communications, radar detection, and precision measurement systems. Techniques such as injection locking and phase-locked loops can suppress phase noise, but they may require external reference sources or incorporate the oscillator into a feedback loop, potentially increasing system complexity and limiting frequency tunability. Injection-locked optoelectronic oscillators can suppress the phase noise of an external microwave signal without incorporating its source into a feedback loop. However, their long optical fiber links are sensitive to environmental disturbances, while the bandwidths of their electrical components constrain the tuning range. As an alternative approach, stimulated Brillouin scattering (SBS) in a fiber ring cavity offers a promising solution to phase-noise suppression owing to its narrowband gain and noise purification capability.
In this paper, a wideband microwave phase-noise suppression method based on a Brillouin fiber ring cavity and frequency-shifted optical selfinjection locking (FSOSIL) is proposed and experimentally demonstrated. The microwave signal to be processed is first transferred to the optical domain through electro-optic modulation. The optical carrier and a firstorder modulation sideband serve as two pump waves to excite SBS in a shared 100 m fiber ring cavity. The SBS process is utilized to suppress phase noise and generate two narrow-linewidth Stokes waves. Furthermore, the shared-cavity configuration suppresses common-mode noise, thereby enhancing the mutual coherence between the two output Stokes waves. The Stokes wave generated by the optical-carrier pump is frequency-shifted and fed back into the distributed-feedback (DFB) laser to establish FSOSIL. This feedback stabilizes the pump frequency and further reduces phase noise. Finally, a low-phase-noise microwave signal is obtained by the beating of the two stabilized Stokes waves at a photodetector.
Experimental results show that, for a 15-GHz input signal, the output achieves a single-sideband phase noise of -117.1 dBc/Hz at a 10-kHz offset, representing a 33.9-dB reduction relative to the input. The output also exhibits a side-mode suppression ratio of 72.2 dB and a linewidth of approximately 2.9 Hz, indicating high spectral purity. The measured output frequency drift is approximately 0.95 kHz over 10 min, demonstrating good frequency stability. Further experiments verify phase-noise suppression at the tested carrier frequencies across the 1–20 GHz range. Throughout the investigated frequency range, the system provides substantial phase-noise suppression, with the output phase noise generally remaining below -110 dBc/Hz at a 10-kHz offset and varying only weakly with the input microwave frequency. A discrete tuning step of approximately 1.93 MHz is demonstrated, consistent with the free spectral range of the approximately 100-m fiber ring cavity. By combining Brillouin-assisted noise suppression with FSOSIL, the system achieves low phase noise and high spectral purity without incorporating the input microwave source into the feedback loop. The proposed method provides a flexible approach to improving the phasenoise performance of microwave signals over a broad carrier-frequency range.