搜索

x
中国物理学会期刊

制备-测量量子比特系统的自测试标准

CSTR: 32037.14.aps.72.20222431

Self-testing criteria for preparing-measuring qubit system

CSTR: 32037.14.aps.72.20222431
PDF
HTML
导出引用
  • 自测试是对所声称量子设备的一种高安全级别验证, 仅根据设备观测到的统计数据来确认设备中所制备的量子态和所执行的测量. 制备-测量场景下量子系统的自测试可依赖于测量统计关联来实现. 目前针对制备-测量场景量子系统自测试的研究比较单一, 只有当统计关联满足一定的不等式要求时才能实现其系统的自测试. 本文进一步提出了制备-测量场景下量子比特态制备集和测量集实现自测试的新标准, 实现了比BB84粒子更多的量子比特态集及测量集的自测试, 这有利于满足实际实验对不同量子态集制备的需求. 此外, 对所提出的标准进行了鲁棒性分析, 使新标准在实验噪声下具有实际意义. 本文的研究增加了量子比特态制备和测量系统自测试标准的多样性, 有利于实际不同非纠缠单量子系统的自测试.

     

    Self-testing is the high-level security verification of a claimed quantum device, confirming the quantum states prepared in the device and the measurements performed based solely on the observed statistics. The statistical correlations can realize the self-testing of the quantum system in the preparing-and-measuring scenario. However, most of previous studies focused on the self-testing of shared entangled states between devices, at present only a few researches are presented and the existing work can only simultaneously self-test the states and measurements when some witness inequalities reach a maximum violation. We focus on four-state preparation and the selected scenarios of two measurements. In this scenario, Armin Tavakoli et al. Tavakoli A, Kaniewski J, Vértesi T, Rosset D, Brunner N 2018 Phys. Rev. A 98 062307 have put forward a criterion based on the dimensional witness violation inequality which can achieve BB84 particles and corresponding Pauli measurements. However, in addition to the maximum violation of the inequality, any statistics with deviation from the maximum deviation cannot be self-tested. Besides, only the BB84 particle preparation and measurements system can be self-tested with that criterion, resulting in a large number of four-state preparation and two measurement systems that cannot be self-tested. Therefore, in this work, in addition to the maximum violation of that dimension inequality, we directly focus on the full observed statistics and further propose some new criteria for self-testing qubit quantum systems in the preparing-and-measiuring scenarios. And the self-testing criteria are proven in an ideal case. We construct a local isometry by using the constructions commonly used in device-independent cases, exchange the target system with the additional system, and realize the self-testing of more qubit state sets and measurement sets than BB84 particles. This meets the requirements for practical experiments to realize various tasks by different quantum state sets. In addition, we perform a robust analysis of the proposed criteria and use fidelity to describe the closeness of the state to the ideal state of the auxiliary system. Finally, an improved dimensional-dependent NPA method is used to optimize the lower bound of the robustness, making the new criteria practical under experimental noise. We use the YALIMP software package in MATLAB and the solver SEDUMI to solve this optimization problem. The present research increases the diversity of qubit state preparations and self-testing of measurement system, which is beneficial to the actual self-testing of different non-entangled single quantum systems.

     

    目录

    /

    返回文章
    返回